<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN"> <html> <head> <meta content="text/html;charset=ISO-8859-1" http-equiv="Content-Type"> <title></title> </head> <body bgcolor="#ffffff" text="#000000"> Okay, I set it up and have the two hdd temps 80 F, a "temp1" which I am guessing is the cpu, but it is reading 260 F!! , 2 fans @ 1000rpm, so they must be case fans, and my voltage readings, which are pretty good. I know I have a sensor to monitor cpu and hs fan speeds because I have a monitor in windows. The cpu temp has to be wrong or it would have burned up by now, but I am going to check in windows to see what I should be getting. I should have a ~4000rpm fan speed on the HS fan too. I didn't even know my case fans had sensors, but I have 3 of the same fans and only 2 readings.... Alexander Dalloz wrote: <blockquote cite="mid1091745563.3433.136.camel@serendipity.dogma.lan" type="cite"> <pre wrap="">Am Fr, den 06.08.2004 schrieb Andrew um 0:29: </pre> <blockquote type="cite"> <pre wrap="">I want gkrellm to be able to report CPU temp & fan speed just like I have it using hddtemp to report hard drive temps. It says no sensors installed, so I googled and found I need lmsensors. I downloaded the source for lmsensor, but then I read that it doesn't comile in 2.6 </pre> </blockquote> <pre wrap=""> lm_sensors is part of Fedora Core 1/2 </pre> <blockquote type="cite"> <pre wrap="">kernels. Since I can't find any rpm file in red carpet, I tried it anyway and followed the instructions, downloaded 2.6 kernel-source and got the i686 config file, but it doesn't compile. How do I get lmsensors working? </pre> </blockquote> <pre wrap=""> yum install lm_sensors sensors-detect hddtemp is available through fedora.us Alexander </pre> </blockquote> </body> </html>