<html><div style='background-color:'><P>2.6.11-1.35_FC3smp</P> <P>After a long installation, we set up a server on wich we installed a sw; one of the netword card starts getting disabled by it self.</P> <P>We think that it may be because the dhcpd.conf may be causing that, but even turning service off it still doesn't work.</P> <P>We tryed the card outside and it works, so isn't a hardware failure, and each time we set up the configuration for it, it only survive a few seconds and keeps failing.</P> <P>eth1 Link encap:Ethernet HWaddr 00:0D:88:2D:DB:47<BR> UP BROADCAST NOTRAILERS MULTICAST MTU:1500 Metric:1<BR> RX packets:21293 errors:0 dropped:0 overruns:0 frame:0<BR> TX packets:1373 errors:0 dropped:0 overruns:0 carrier:0<BR> collisions:0 txqueuelen:1000<BR> RX bytes:1750818 (1.6 MiB) TX bytes:196495 (191.8 KiB)<BR> Interrupt:169 Base address:0x2400<BR></P> <P>...no ip assigned, even after we did it....</P> <P>Aug 11 01:16:27 dhcp-mpt dhcpd: receive_packet failed on eth0: Network is down<BR>Aug 11 01:16:27 dhcp-mpt NetworkManager: SWITCH: old device no longer good, but no better device was available<BR>Aug 11 01:16:27 dhcp-mpt network: Interrupción de la interfaz eth0: succeeded<BR>Aug 11 01:16:27 dhcp-mpt network: Interrupción de la interfaz eth1: succeeded<BR>Aug 11 01:16:27 dhcp-mpt network: Interrupción de la interfaz de loopback: succeded<BR>Aug 11 01:16:27 dhcp-mpt sysctl: net.ipv4.ip_forward = 0<BR>Aug 11 01:16:27 dhcp-mpt sysctl: kernel.sysrq = 0<BR>Aug 11 01:16:27 dhcp-mpt sysctl: net.ipv4.conf.default.accept_source_route = 0<BR>Aug 11 01:16:27 dhcp-mpt sysctl: net.ipv4.conf.default.rp_filter = 1<BR>Aug 11 01:16:27 dhcp-mpt sysctl: kernel.core_uses_pid = 1<BR>Aug 11 01:16:27 dhcp-mpt network: Configurando parámetros de red: succeeded<BR>Aug 11 01:16:27 dhcp-mpt kernel: ip_tables: (C) 2000-2002 Netfilter core team<BR>Aug 11 01:16:27 dhcp-mpt kernel: Disabled Privacy Extensions on device c036dcc0(lo)<BR>Aug 11 01:16:28 dhcp-mpt network: Activación de la interfaz de loopback: succeded<BR>Aug 11 01:16:28 dhcp-mpt kernel: ip_tables: (C) 2000-2002 Netfilter core team<BR>Aug 11 01:16:29 dhcp-mpt kernel: tg3: eth0: Link is up at 100 Mbps, full duplex.<BR>Aug 11 01:16:29 dhcp-mpt kernel: tg3: eth0: Flow control is on for TX and on for RX.<BR>Aug 11 01:16:29 dhcp-mpt NetworkManager: SWITCH: best device changed<BR>Aug 11 01:16:29 dhcp-mpt NetworkManager: Activation (eth0) started...<BR>Aug 11 01:16:30 dhcp-mpt network: Activando interfaz eth0: succeeded<BR>Aug 11 01:16:30 dhcp-mpt kernel: ip_tables: (C) 2000-2002 Netfilter core team<BR>Aug 11 01:16:30 dhcp-mpt kernel: eth1: link down<BR>Aug 11 01:16:31 dhcp-mpt NetworkManager: Restarting mDNSResponder.<BR>Aug 11 01:16:31 dhcp-mpt NetworkManager: Activation (eth0) successful, device activated.<BR>Aug 11 01:16:32 dhcp-mpt network: Activando interfaz eth1: succeeded<BR></P> <P>last part of /var/log/messages (sorry about the spanish), i did it, then inmediatly i checked ifconfig and ip was assigned, then i checked ifconfig again, and it was gone...</P> <P>Any ideas?<BR></P><BR><BR><BR> <DIV> <DIV> <DIV>Daniel Vogel </DIV>exed@hotmail.com <DIV></DIV>Computer Engineering. <DIV></DIV>Concepcion-Chile </DIV> <DIV align=right><EM> <DIV align=right><EM>Siempre sale el sol despues de la tormenta.</EM></DIV></EM></DIV></DIV><BR><BR><BR>>From: yufan <iamyufan@gmail.com><BR>>Reply-To: For users of Fedora Core releases <fedora-list@redhat.com><BR>>To: For users of Fedora Core releases <fedora-list@redhat.com><BR>>Subject: Is there a way to open a website which supports IE only in Fedora?<BR>>Date: Thu, 11 Aug 2005 12:44:43 +0800<BR>><BR>>Hello all,<BR>>i wanna enter a chatting website which most probabily contains some ASP<BR>>staff hence Firefox fails to do that and it says "this website requires IE<BR>>4.0 or above".Is there a way to solve this problem?Thanks in advance.<BR>>yufan<BR>>--<BR>>fedora-list mailing list<BR>>fedora-list@redhat.com<BR>>To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list<BR></div></html>