<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 TRANSITIONAL//EN"> <HTML> <HEAD> <META HTTP-EQUIV="Content-Type" CONTENT="text/html; CHARSET=UTF-8"> <META NAME="GENERATOR" CONTENT="GtkHTML/3.6.2"> </HEAD> <BODY> Only caught the tail end of Craigs post, so this might be a similar post, so I did look at the tests with the same results. Here are my details, so any help is appreciated. I am trying to sync Treo 600, there is an entry in the devices.xml for it:  <device vendor_id="082d" product_id="0300" /> I also have the following RPM's installed: gnome-pilot-2.0.13-2 gnome-pilot-devel-2.0.13-2 gnome-pilot-conduits-2.0.13-1 pilot-link-debuginfo-0.12.0-0.pre4.0.fc4.2 pilot-link-devel-0.12.0-0.pre4.0.fc4.2 pilot-link-0.12.0-0.pre4.0.fc4.2 jpilot-0.99.8-0.pre10.fc4.1 jpilot-debuginfo-0.99.8-0.pre10.fc4.1 Once I plug in the device (not hitting the sync I get the following: Nov 7 16:24:15 vader kernel: usb 2-1: new full speed USB device using uhci_hcd and address 6 Nov 7 16:24:15 vader kernel: visor 2-1:1.0: Handspring Visor / Palm OS converter detected Nov 7 16:24:15 vader kernel: usb 2-1: Handspring Visor / Palm OS converter now attached to ttyUSB2 Nov 7 16:24:15 vader kernel: usb 2-1: Handspring Visor / Palm OS converter now attached to ttyUSB3 Nov 7 16:24:38 vader kernel: usb 2-1: USB disconnect, address 6 I did issue the commands in the previous thread, <TT>pilot-xfer -L -p /tmp/pilot</TT> it sits and waits for connection, even after pressing the hot-sync button there is nothing. Once disconnected you recieve Nov 7 16:26:04 vader kernel: visor ttyUSB0: Handspring Visor / Palm OS converter now disconnected from ttyUSB0 Nov 7 16:26:05 vader kernel: visor ttyUSB1: Handspring Visor / Palm OS converter now disconnected from ttyUSB1 I would like to sync w/ evolution, if it must be a jpilot type app, so be it, but any help to get this going is appreciated. Lance <TABLE CELLSPACING="0" CELLPADDING="0" WIDTH="100%"> <TR> <TD> <PRE> -- .~. /V\ // \\ /( )\ ^`~'^ </PRE> </TD> </TR> </TABLE> </BODY> </HTML>