Problem was fixed by installing CentOS 4.4, which recognised all controlers and disks out-of-the-box. ---------- Forwarded message ---------- From: Andrew Mather <<a href="mailto:mathera@gmail.com">mathera@gmail.com</a>> Date: Dec 12, 2006 6:15 PM Subject: FC6 on Dell Poweredge 6300 To: <a href="http://www.abc.net.au/news/newsitems/200612/s1810177.htm">http://www.abc.net.au/news/newsitems/200612/s1810177.htm </a> Hi All, I'm trying to install FC6 on an (ancient) Dell Poweredge 6300 machine that's currently running RH7.2. It's a quad-xeon 500MHz machine with 4Gb of RAM. It has a bunch of SCSI drives attached to an Adaptec 7840 (or is it 7860, not near the machine right now) SCSI controller. There are two other Adaptec controllers in the machine, one of which has the tape drive and CDROM. of the 3 controllers, 2 are the same (either 7840, or 7860) and the other is the other of these. Now that's clear isn't it ? ;-) The installer just keeps rebooting the machine at the point where it tries to load the aic7xxx diver module. We've tried booting with the noprobe option and then manually loading the module and have tried a couple of options to the module itself, but it either hangs, or reboots at the same point. At one point, we got it to the graphical installer stage, but no drives were visible. Has anyone managed to get FC6 (or even 5 or 4 will do) on this sort of hardware and if so, are there any tips you could pass on, or resources we could find ? Google hasn't been much help. Thanks, Andrew