ethtool result..........<br><br><br> ethtool eth0<br>Settings for eth0:<br> Supported ports: [ TP MII ]<br> Supported link modes: 10baseT/Half 10baseT/Full<br> 100baseT/Half 100baseT/Full<br> Supports auto-negotiation: Yes<br> Advertised link modes: Not reported<br> Advertised auto-negotiation: No<br> Speed: 10Mb/s<br> Duplex: Half<br> Port: MII<br> PHYAD: 32<br> Transceiver: internal<br> Auto-negotiation: off<br> Current message level: 0x00000000 (0)<br> Link detected: no<br><br><br><div class="gmail_quote">2009/9/12 Jorge Fсbregas <span dir="ltr"><<a href="mailto:jorge.fabregas@gmail.com">jorge.fabregas@gmail.com</a>></span><br> <blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;"><div class="im">On Saturday 12 September 2009 02:01:33 pm sureshbabu ct wrote:<br> > eth0: 10 Mbit, half duplex, no link<br> <br> </div>If I remember well..even if the interface drops to half-duplex, you shouldn't<br> see "no link" on the mii-tool output. Does "ethtool eth0" show no link as<br> well? Did you check the LED on the card? Is the port on the switch<br> configured auto or manually? That's what I would do...<br> <div><div></div><div class="h5"><br> HTH,<br> Jorge<br> <br> --<br> fedora-list mailing list<br> <a href="mailto:fedora-list@redhat.com">fedora-list@redhat.com</a><br> To unsubscribe: <a href="https://www.redhat.com/mailman/listinfo/fedora-list" target="_blank">https://www.redhat.com/mailman/listinfo/fedora-list</a><br> Guidelines: <a href="http://fedoraproject.org/wiki/Communicate/MailingListGuidelines" target="_blank">http://fedoraproject.org/wiki/Communicate/MailingListGuidelines</a><br> </div></div></blockquote></div><br><br clear="all"><br>-- <br><br> (Ј`З.ЗДЈ) with<br> `З.И(Ј`З.ЗДЈ) Luv<br> (Ј`З.ЗДЈ)И.ЗД Suresh Vellinezhi.<br> `З.И.ЗД<br>