<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 TRANSITIONAL//EN">
<HTML>
<HEAD>
<META HTTP-EQUIV="Content-Type" CONTENT="text/html; CHARSET=UTF-8">
<META NAME="GENERATOR" CONTENT="GtkHTML/3.6.2">
</HEAD>
<BODY>
On Thu, 2006-02-16 at 13:39 -0500, Sam Folk-Williams wrote:
<BLOCKQUOTE TYPE=CITE>
<PRE>
<FONT COLOR="#000000">-----BEGIN PGP SIGNED MESSAGE-----</FONT>
<FONT COLOR="#000000">Hash: SHA1</FONT>
<FONT COLOR="#000000">Jairaj Menon wrote:</FONT>
<FONT COLOR="#000000">> I am new to xen and trying to setup the same on a fc4 base. I would like</FONT>
<FONT COLOR="#000000">> to setup two guest OS on xen FC3 and FC4. </FONT>
<FONT COLOR="#000000">> I blindly followed fedoraXenQuickstart url and installed FC3</FONT>
<FONT COLOR="#000000">> base...everything worked fine so far ...i was able to initialize my FC3</FONT>
<FONT COLOR="#000000">> guest OS as well...but it shows no network interface. </FONT>
<FONT COLOR="#000000">> Can anyone help me to understand how can i bring the my FC3 guest OS on</FONT>
<FONT COLOR="#000000">> the network.. ? </FONT>
<FONT COLOR="#000000">> </FONT>
<FONT COLOR="#000000">> Any help would be appreciated!</FONT>
<FONT COLOR="#000000">> </FONT>
<FONT COLOR="#000000">> Thanks.</FONT>
<FONT COLOR="#000000">> Jairaj Menon</FONT>
<FONT COLOR="#000000">> </FONT>
<FONT COLOR="#000000">> </FONT>
<FONT COLOR="#000000">> </FONT>
<FONT COLOR="#000000">> ------------------------------------------------------------------------</FONT>
<FONT COLOR="#000000">> </FONT>
<FONT COLOR="#000000">> --</FONT>
<FONT COLOR="#000000">> Fedora-xen mailing list</FONT>
<FONT COLOR="#000000">> <A HREF="mailto:Fedora-xen@redhat.com">Fedora-xen@redhat.com</A></FONT>
<FONT COLOR="#000000">> <A HREF="https://www.redhat.com/mailman/listinfo/fedora-xen">https://www.redhat.com/mailman/listinfo/fedora-xen</A></FONT>
<FONT COLOR="#000000">Hi,</FONT>
<FONT COLOR="#000000">When you are logged into the guest, can you do "netconfig" to set up a</FONT>
<FONT COLOR="#000000">network device? This seems not to happen on FC3/4 automatically; after</FONT>
<FONT COLOR="#000000">you run this command you should be able to access the network.</FONT>
<FONT COLOR="#000000">Thanks,</FONT>
<FONT COLOR="#000000">Sam</FONT>
</PRE>
</BLOCKQUOTE>
<BR>
Sam,<BR>
Yes..i can run setup command and configure eth0, but when i execure 'service network restart', i see no output...same is the case after issuing 'ifconfig'. I am not sure whats missing..same behaviour is observed for FC3 and FC4 guests. I spent a lot of time searching the net in case any one else faced similar problem and i am surprised...i never got a single thread on this.<BR>
<BR>
Thanks.<BR>
Jairaj Menon
</BODY>
</HTML>