<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;">Mark, Could you share your .config for JF's 2.6.31-rc8 which loads under Xen Unstable. Looks like i miss some point tuning kernel. Thanks. Boris. --- On Fri, 9/4/09, Boris Derzhavets <bderzhavets@yahoo.com> wrote: <blockquote style="border-left: 2px solid rgb(16, 16, 255); margin-left: 5px; padding-left: 5px;"> From: Boris Derzhavets <bderzhavets@yahoo.com> Subject: [Xen-devel] Re: [Fedora-xen] Xorg on JF 2.6.31-rc8 with xen 3.5 unstable To: fedora-xen@redhat.com, "Mark Schloesser" <mark.schloesser@rwth-aachen.de> Cc: xen-devel@lists.xensource.com Date: Friday, September 4, 2009, 2:02 PM <div id="yiv1803048465"><table border="0" cellpadding="0" cellspacing="0"><tbody><tr><td style="font-family: inherit; font-style: inherit; font-variant: inherit; font-weight: inherit; font-size: inherit; line-height: inherit; font-size-adjust: inherit; font-stretch: inherit; -x-system-font: none;" valign="top">I did "git pull" , built 2.6.31-c8 kernel with Xen Dom0 support. However, attempt to load kernel under Xen 3.4.1 drops into stack trace and hangs on both F11 and Ubuntu 9.10. Old 2.6.31-rc6's .config file has been used without any changes. I can't set up serial console in meantime. Boris --- On Fri, 9/4/09, Mark Schloesser <mark.schloesser@rwth-aachen.de> wrote: <blockquote style="border-left: 2px solid rgb(16, 16, 255); margin-left: 5px; padding-left: 5px;"> From: Mark Schloesser <mark.schloesser@rwth-aachen.de> Subject: [Fedora-xen] Xorg on JF 2.6.31-rc8 with xen 3.5 unstable To: fedora-xen@redhat.com Date: Friday, September 4, 2009, 10:26 AM <div class="plainMail">Hey guys, I sadly had no luck fixing my X problem. The system seems to run fine and as the subject says I moved from 3.4.1-3 to xen-unstable. As I am already doing fairly bleeding-edge stuff here I thought this would probably make most sense. As I only have an nvs290 gfx card available right now I can't check if this is the problem. But I'll try to get my hands on some other cards for next week. Today I read through a lot of mailing list archives and PDFs trying to dig deeper into the IOMMU/PCI passthrough stuff and I want to give the graphics passthrough situation a shot myself. Sadly it is very confusing to read about the different setups and hardware environments with both positive and negative results. Also the patchsets and versions everybody is talking about do not make it any easier :) My current questions would be: - is the combination of JF git kernel with xen-unstable the right way to go for this setup? Or should I perhaps use older xen version and apply some patchset? I think some of those patches were applied in xen-unstable already but I am not quite sure... - does anyone have hints or clarification regarding the Xorg problem on dom0? As I said there are no eye-catching log entries or errors except the Xorg backtrace at the end of the log file (posted to list before). This happens regardless of which driver I enable (vesa/nv/nouveau). The nvidia binary driver compiles without problems and seems to come up but only gives me a black screen and also locks the vtys. Thanks to the great help, reports and instructions Boris and others! Mark </div> -----Inline Attachment Follows----- <div class="plainMail">-- Fedora-xen mailing list <a rel="nofollow">Fedora-xen@redhat.com</a> <a rel="nofollow" target="_blank" href="https://www.redhat.com/mailman/listinfo/fedora-xen">https://www.redhat.com/mailman/listinfo/fedora-xen</a> </div></blockquote></td></tr></tbody></table> </div> -----Inline Attachment Follows----- <div class="plainMail">_______________________________________________ Xen-devel mailing list <a ymailto="mailto:Xen-devel@lists.xensource.com" href="/mc/compose?to=Xen-devel@lists.xensource.com">Xen-devel@lists.xensource.com</a> <a href="http://lists.xensource.com/xen-devel" target="_blank">http://lists.xensource.com/xen-devel</a> </div></blockquote></td></tr></table>