Re: Module loading

[Iain Conochie <iain uk colt net>]

Brian Long wrote:
> Iain Conochie wrote:
>
> > Morning,
> >
> >     Is it possible to stop the auto probe on a 3.0AS kickstart 
> > installation? I have an adaptec SAS controller card, and the install 
> > program mistakenly uses the aacraid driver to support this device. I 
> > have a drivers disk from IBM (this is an x366 server) which contains 
> > the correct driver but the install program loads the aacraid driver 
> > before i have a chance of using the IBM supplied driver!
> >
> >     Any ideas? Anyone managed to successfully install on this server?
> >
> > Cheers
>
>
> You could pass 'nostorage' to newer RHEL 3 kickstarts and it won't probe 
> any storage.  Make sure you also add 'dd' so it prompts for the driver 
> disk.
>
> /Brian/

Cheers Brian. I found that passing 'noprobe' works as well, however I 
have to manually add the network driver to make sure kickstart worked.

In the end I had to put AS 4.0 on this as none of the drivers seem to 
support the Adaptec SAS card....

Cheers

Iain

> _______________________________________________
> Kickstart-list mailing list
> Kickstart-list redhat com
> https://www.redhat.com/mailman/listinfo/kickstart-list


--
Iain Conochie UNIX System Administrator UK
COLT Telecom
Units 9-13 Powergate Business Centre, Volt Avenue, London NW10 6PW
Tel: +44 (0) 20 7947 1286
Tel: +44 (0) 78 1514 5493
Email: iain conochie colt net
www.colt.net