Re: Kickstart and multi-disks servers

[Stephen Mah <smah vmware com>]

It's in the Red Hat document: http://www.redhat.com/docs/manuals/enterprise/RHEL-4-Manual/pdf/rhel-sag-en.pdf (page 20)
look for %part-include.
I'm using it after the "install" directive. I initially had it near the end of the kickstart before %pre, but didn't seem to work.

-regards
steve

Shabazian, Chip wrote:

We have covered this many times in the past.  You can get some great
examples by searching through the archive.

Chip 

-----Original Message-----
From: kickstart-list-bounces redhat com
[mailto:kickstart-list-bounces redhat com] On Behalf Of Jim Wildman
Sent: Wednesday, January 17, 2007 6:27 AM
To: Discussion list about Kickstart
Subject: Re: Kickstart and multi-disks servers


On Wed, 17 Jan 2007, Jason Edgecombe wrote:

  

I use a shell script in my %pre to detect for sda/hda and write the 
proper disk lines.

Sincerely,
Jason
    

Would you be able to share that script?  I'm always looking for
new/other ways to work in %pre.

------------------------------------------------------------------------
Jim Wildman, CISSP, RHCE       jim rossberry com
http://www.rossberry.com
"Society in every state is a blessing, but Government, even in its best
state, is a necessary evil; in its worst state, an intolerable one."
Thomas Paine

_______________________________________________
Kickstart-list mailing list
Kickstart-list redhat com
https://www.redhat.com/mailman/listinfo/kickstart-list

_______________________________________________
Kickstart-list mailing list
Kickstart-list redhat com
https://www.redhat.com/mailman/listinfo/kickstart-list