Hi, First off, I’d like to thank Chip, Mike and Colin for their help earlier. I was asked to postpone this project for about a week but eventually I experimented with different setups and managed to create a kickstart environment that utilizes PXE boot. Well, now I’m getting this strange error message after the client boots off the PXE/DHCP server: * running dhcp for eth0 * pump told us: No DHCP reply received * eth0 isn’t a wireless adapter It looks like the DHCP server can’t assign an ip. This error is a little confusing because the kickstart client is definitely getting an IP from the DHCP server which allows it to boot into PXE. After initially getting an IP to boot into PXE, anaconda begins to install the driver modules. What I then see is various drivers loading like the megaraid SCSI, megaraid SAS and NIC drivers. The installation just halts when it asks me for the networking info. Here’s what I tried: I tried to do a kick off of a Dell 1950 and 2950. I tried to boot off of both NICs to no avail I connected a crossover cable from the kickstart client directly to the DHCP/PXE server. I get the same results. An initial ip is assigned the first time for a PXE boot but doesn’t subsequently get one during the anaconda install phase. Any suggestions would be VERY helpful. I can’t find any useful info about this error message on google. Thanks in advance, anthony <hr size=1>Everyone is raving about <a href="http://us.rd.yahoo.com/evt=42297/*http://advision.webevents.yahoo.com/mailbeta">the all-new Yahoo! Mail beta</a>.