<div dir="ltr">I am having some issue with LibVirt installation from source code. I downloaded the latest code from git, was able to configure and compile it. But when I try to install it using <i><b>sudo make install</b>i, </i>I get the following errors.<div><br></div><div><br></div><div><div>Making install in po</div><div>make[1]: Entering directory '~/libvirt/po'</div><div>make[2]: Entering directory '~/libvirt/po'</div><div>make[2]: Nothing to be done for 'install-exec-am'.</div><div>make  install-data-hook</div><div>make[3]: Entering directory '~/libvirt/po'</div><div>make[3]: *** No rule to make target 'af.gmo', needed by 'install-data-hook'.  Stop.</div><div>make[3]: Leaving directory '~/libvirt/po'</div><div>Makefile:2027: recipe for target 'install-data-am' failed</div><div>make[2]: *** [install-data-am] Error 2</div><div>make[2]: Leaving directory '~/libvirt/po'</div><div>Makefile:1981: recipe for target 'install-am' failed</div><div>make[1]: *** [install-am] Error 2</div><div>make[1]: Leaving directory '~/libvirt/po'</div><div>Makefile:2105: recipe for target 'install-recursive' failed</div><div>make: *** [install-recursive] Error 1</div></div><div><br></div><div><br></div><div>As I mentioned, there is no error during compiling the source code. It would be helpful if someone could point me in a direction so I can figure out the problem.</div><div><br></div><div><br></div><div>Thanks</div><div>Azizul Hakim</div></div>