Ok. Thanks for your prompt reply. I have another question - Is there any way in which "using the Command Line Interface" we can find the version of the Cluster Suite which has been installed? Thanks a lot again. Regards, Chaitanya <div class="gmail_quote">On Wed, Jan 14, 2009 at 4:02 PM, Chrissie Caulfield <<a href="mailto:ccaulfie@redhat.com">ccaulfie@redhat.com</a>> wrote: <blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;"> <div class="Ih2E3d">Chaitanya Kulkarni wrote: > Hi, > > Following is output of my cman_tool status - > > Protocol version: 5.0.1 > Config version: 40 > Cluster name: cluster1 > Cluster ID: 39377 > Cluster Member: Yes > Membership state: Cluster-Member > Nodes: 2 > Expected_votes: 1 > Total_votes: 2 > Quorum: 1 > Active subsystems: 4 > Node name: node1 > Node addresses: <IP Address of the node> > > Can anyone please explain me what the fields "Protocol version" and > "Config version" mean? > > </div>Hiya Protocol Version: is the version number of the communications protocol used by cman over openais. It doesn't change much! You might see 5.2.0 on some later systems. Config Version is the version number taken from cluster.conf. Hope this helps, Chrissie -- Linux-cluster mailing list <a href="mailto:Linux-cluster@redhat.com">Linux-cluster@redhat.com</a> <a href="https://www.redhat.com/mailman/listinfo/linux-cluster" target="_blank">https://www.redhat.com/mailman/listinfo/linux-cluster</a> </blockquote></div>