<DIV>Any guidance on the best way to downgrade? Yum doesnt seem to do this and I get a number of dependencies using rpm - libdevmapper.so.1.00, libdevmapper.so.1.00(base) and libreadline.so.4 </DIV> <DIV> </DIV> <DIV>Thanks, John Richard Ray <rray@mstc.state.ms.us> wrote:</DIV> <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">I had a similar problem with FC4. lvm2-2.01 has problems. Downgrade to lvm2-2.00 from FC3. Richard On Tue, 16 Aug 2005 john_gore@yahoo.com wrote: > My vg mounts fine under fc3, but when i installed fc4 on a new drive, I cant bring in the vg. I get errors for hdc like "Couldn't find device with uuid..." and PV unknown device (from pvscan). > > I can plug back in the old boot drive and run under fc3 and things work well. > > The vg consists of 1 lv and 2 pv drives configured as: > > my_vg: > my_lv1: > hdc2 (ext2) > hdd (single partition as ext2) > > The old hda boot disk is ext3 running FC3 and the new hda boot disk is running the dafault lvm partitions under FC4. > > hdc is formatted with boot and swap on hdc1 and hdc5 - probably this was from an earlier install (althoug! h I did have these disks plugged in while installing FC4 - when the installer started asking about reformatting hdc and hdd, I powered down, unplugged these drives, and redid the install) > > Any ideas to try? > > - John > > > _______________________________________________ linux-lvm mailing list linux-lvm@redhat.com https://www.redhat.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/ </BLOCKQUOTE>