<tt>rhelv6-list-bounces@redhat.com schrieb am 27.09.2012 13:37:29: > Brian Long <brilong@cisco.com> </tt> <tt>> Gesendet von: rhelv6-list-bounces@redhat.com > </tt> <tt>> 27.09.2012 13:39</tt> <tt>> > Bitte antworten an > "Red Hat Enterprise Linux 6 \(Santiago\) discussion mailing-list" > <rhelv6-list@redhat.com></tt> <tt>> > An</tt> <tt>> > "Red Hat Enterprise Linux 6 (Santiago) discussion mailing-list" > <rhelv6-list@redhat.com></tt> <tt>> > Kopie</tt> <tt>> > Thema</tt> <tt>> > Re: [rhelv6-list] MD devices lost after boot</tt> <tt>> > On Sep 27, 2012, at 3:05 AM, Roth, Sandro wrote:</tt> <tt>> > Hi experts</tt> <tt>> </tt> <tt>> I wasn’t sure where to post this so I’m sending it to this list.</tt> <tt>> </tt> <tt>> We have a setup which uses lvm over md over multipath devices. (at > least that’s the plan)</tt> <tt>> According to this article it is supported in RHEL6 (it wasn’t in RHEL5)</tt> <tt>> </tt><a href=https://access.redhat.com/knowledge/solutions/48634><tt>https://access.redhat.com/knowledge/solutions/48634</tt></a> <tt>> </tt> <tt>> I created my md device as follows</tt> <tt>> # mdadm --create --verbose /dev/md0 --level=1 --raid-devices=2 /dev/ > mapper/mpatha /dev/mapper/mpathb</tt> <tt>> > Do /dev/mapper/mpatha and mpathb have partition type of "fd - Linux > RAID auto"? If not, they won't be set up properly when booting the server.</tt> <tt>> > /Brian/_______________________________________________ > rhelv6-list mailing list > rhelv6-list@redhat.com > </tt><a href="https://www.redhat.com/mailman/listinfo/rhelv6-list"><tt>https://www.redhat.com/mailman/listinfo/rhelv6-list</tt></a> <tt>Hi Brian,</tt> <tt>sorry you're not right. There is no need for partitions with lvm. You can use the whole disk without partitions.</tt> Mit freundlichen Grüßen Andreas Reschke ________________________________________________________________ Unix/Linux-Administration Andreas.Reschke@behrgroup.com