<html> <body> I'm running RHEL 4 update 2 on a wx4300 HP workstation (EM64T processor). I've installed RHEL 4 x86_64 WS. I have now put in a SysKonnect FDDI card and tried to configure it, but am having problems. Here are the steps I did: made the skfp.ko module by 1. rpm -Uvh kernel-2.6.9-22.EL.src.rpm 2. cd /usr/src/redhat/SPECS 3. rpmbuild -bp --target=x86_64 kernel-2.6.spec 4. cd /usr/src/redhat/BUILD/kernel-2.6.9/linux-2.6.9/ 5. cp configs/kernel-2.6.9-x86_64-smp.config .config 6. make menuconfig (selected Device Drivers/networking support/FDDI driver support and made sure SysKonnect FDDI PCI support was set as M) 6. make modules 7. cp drivers/net/skfp/skfp.ko to /lib/modules/2.6.9-22.0.1.ELsmp/kernel/drivers/net/ 8. depmod -a After a reboot I was prompted by kudzu to configure the device fddi0. I configured with our network settings and continued. It then gave an error like "skfp device fddi0 does not seem to be installed" and will not connect the FDDI device. Can you please help. Here's the lspci output for the card: 05:09.0 FDDI network controller: SysKonnect FDDI Adapter (rev 13) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (1000ns min, 10000ns max), Cache Line Size 10 Interrupt: pin A routed to IRQ 161 Region 0: Memory at e8a00000 (32-bit, non-prefetchable) [size=2K] Region 1: I/O ports at 1000 [size=256] Any help would be apprecriated. Thanks! <x-sigsep></x-sigsep> Brad Sharpe (bsharpe@mda.ca) Computing Services MacDonald Dettwiler & Associates (604) 231-2669 "Wisdom is ofttimes nearer when we stoop, than when we soar." William Wordsworth </body> </html>