<div dir="ltr">Previous questions were about the failure of updating CentOS from the Spacewalk server.  I was getting the following error:<div><br></div><div>local action status: ((6,), 'Fatal error in Python code occurred', {})</div><div><br></div><div>I searched and searched and searched, posted questions and no one was able to answer the question on what the error was, and how to resolve it.  </div><div><br></div><div>The only reply that I received on this board was that this was a bug that had been fixed in RH Satellite Server, but apparently not in Spacewalk.  </div><div><br></div><div>Perhaps this is a known bug that was only fixed in RH Satellite and not addressed in SW because I found other postings with the exact same issue.  These postings go back for over a year, so I know this has been an issue for sometime.  Almost all of these posts have the same replies: execute a yum clean all, update yum, etc...  I did all of that as well as did the others in who have the same issue.  Stop/start the satellite server etc....</div><div><br></div><div>Finally, I found a posting by a guy who jumped through all of the hoops, as had I, but finally found out that removing the "s" from the https://<sp-walk server> in /usr/sysconfig/rhn/up2date resolved the issue.</div><div><br></div><div>I successfully updated my CentOS 6.5 server.</div><div><br></div><div>Thank you</div><div><br></div><div>Daryl</div><div><div><br></div></div></div>