UP2000+ Problems

[Dialup Jon Norstog]

Will, list:

The PSU I used was the Enermax EX465V AX-VE(W.  It has the Aux 6-pin connector
as well as the 4-pin and the ATX connector.  I ran the board bare, no case,
with an off-brand Permedia 2 card, no other peripherals. 

I was able to load and run some of last year's Fedora "distros" on it before
donating it to a guy in Austria who I thought was going to use it helping out
on the Fedora project.

It was just too hot and noisy ...

jn

---------- Original Message -----------
From: "Will L Givens" <diskman at kc.rr.com>
To: "'Linux on Alpha processors'" <axp-list at redhat.com>
Sent: Mon, 22 Feb 2010 19:21:08 -0600
Subject: RE: UP2000+ Problems

> Just going over the "UP2000 Technical Reference Manual" and on page 
> 2-3 (aka 19 of 91) it states "AUX ATX (Optional) Power Connector for 
> 3.3v (6 pin)". Will L G
> 
> > -----Original Message-----
> > From: axp-list-bounces at redhat.com [mailto:axp-list-bounces at redhat.com]
> > On Behalf Of jmd
> > Sent: Monday, February 22, 2010 04:13
> > To: Linux on Alpha processors
> > Subject: Re: UP2000+ Problems
> > 
> > Jon...
> > 
> > the only power supply i have here is a 300W. hardly powerful enough to
> > power even 1 cpu on that board. i did read the power requirements in
> > the
> > user manual. if i were going to buy one i would sink $50 or more in it,
> > plus i would have to obtain an adapter for the J28 connector. with tax
> > and shipping, i would guess $80 or more.
> > 
> > another consideration is the cheaper power supplies are usually atx for
> > a tower configuration. i have the powerrac server enclosure. the
> > configuration is a bit different. including setting jumpers for
> > tower/server configurations.
> > 
> > as matt mentioned, a couple of people in the alpha IRC channel thought
> > of the power supply, but others had mentioned possibly buggy firmware.
> > that being the cheapest route was what i wanted to address first.
> > 
> > i am doing as much testing as i can, without spending a lot of money,
> > before i put it up on ebay for sale.
> > 
> > thanks for your input...
> > 
> > jeff
> > 
> > 
> > 
> > On Mon, 2010-02-22 at 09:14 -0700, Dialup Jon Norstog wrote:
> > > Jeff,
> > >
> > > I was able to run a UP2000+ 2x667 and full load of RAM off an Enermax
> > 450W
> > > power supply, the quiet model.  That was with a single SCSI hard
> > drive and a
> > > CDROM.  It was barely enough rated power but that particular PSU must
> > have a
> > > little reserve capacity.
> > >
> > > If you have a comparable PSU you might try using it to test your
> > board.  Just
> > > a thought.
> > >
> > > jn
> > >
> > >
> > > ---------- Original Message -----------
> > > From: jmd <jmd8800 at charter.net>
> > > To: Linux on Alpha processors <axp-list at redhat.com>
> > > Sent: Fri, 19 Feb 2010 13:08:06 -0800
> > > Subject: Re: UP2000+ Problems
> > >
> > > > On Fri, 2010-02-19 at 15:41 -0500, Matt Turner wrote:
> > > >
> > > > >
> > > > > If the problem persists with a working power supply, then we
> > might
> > > > > consider that the CPUs or motherboard are somehow faulty. The
> > CPUs
> > > > > were run with a higher (read: wrong) voltage for a non-trivial
> > amount
> > > > > of time after all.
> > > > >
> > > > > Matt Turner
> > > >
> > > > i should have stated i am not interested in investing any money in
> > this
> > > > board. good power supplies are not cheap.
> > > >
> > > > thanks
> > > > jeff duncan
> > > >
> > > > _______________________________________________
> > > > axp-list mailing list
> > > > axp-list at redhat.com
> > > > https://www.redhat.com/mailman/listinfo/axp-list
> > > >
> > > > --
> > > > This message has been scanned for viruses and
> > > > dangerous content by MailScanner, and is
> > > > believed to be clean.
> > > ------- End of Original Message -------
> > >
> > > _______________________________________________
> > > axp-list mailing list
> > > axp-list at redhat.com
> > > https://www.redhat.com/mailman/listinfo/axp-list
> > 
> > 
> > _______________________________________________
> > axp-list mailing list
> > axp-list at redhat.com
> > https://www.redhat.com/mailman/listinfo/axp-list
> 
> _______________________________________________
> axp-list mailing list
> axp-list at redhat.com
> https://www.redhat.com/mailman/listinfo/axp-list
> 
> -- 
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
------- End of Original Message -------