FC4 installation

[Janina Sajka]

Depends on the SATA, I think. There have been complaints of some SATA
not working, while others are just fine. You should not need to do
anything special, but it does really seem to depend on the hw.

I have a raid 5 array made up of SATA drives on a 3Ware controller and
it just works. I did nothing special to configure it.

However, taking the same hd and attaching using the on board sata
controller did not work.

Osvaldo writes:
> Hi,
> 
> Should it be possible that you have to pass some param not listed in the F4
> helpmenu to support SATA detection? a good friend of mine tried this morning
> FC4, he was only able to boot after providing the noprobe param, but then
> Fedora only shows his hda disk, NOT the SATA.
> 
> Any suggestion?
> 
> Thnx,
> 
> Aldo.
> 
> _______________________________________________
> Blinux-list mailing list
> Blinux-list at redhat.com
> https://www.redhat.com/mailman/listinfo/blinux-list

-- 

Janina Sajka				Phone: +1.202.494.7040
Partner, Capital Accessibility LLC	http://www.CapitalAccessibility.Com

Bringing the Owasys 22C screenless cell phone to the U.S. and Canada. Go to http://www.ScreenlessPhone.Com to learn more.

Chair, Accessibility Workgroup		Free Standards Group (FSG)
janina at freestandards.org		http://a11y.org