[dm-devel] not all paths working at boot
Ed Wilts
ewilts at ewilts.org
Thu Aug 3 21:02:52 UTC 2006
On Thu, Aug 03, 2006 at 03:41:31PM -0400, Eddie Williams wrote:
>
> If you can, upgrade to 4.004 firmware. This makes the EVA active/active
> and perhaps will resolve your problems. It definitely makes it work
> better!
This is a *major* change that most customers are not doing because of
the significance of it. I'm not saying that it's a bad thing but this
*MUST* be planned very, very carefully and even then, if it goes wrong,
you have the potential to lose the frame since there is no roll-back.
.../Ed
>
> Eddie
> On Thu, 2006-08-03 at 12:29 -0500, Ed Wilts wrote:
> > On Thu, Aug 03, 2006 at 02:54:47PM +0100, Dave Holland wrote:
> > > I have a problem with multipath-tools 0.4.7 (I also tried the latest
> > > "git" version) running on Debian (mix of stable/unstable), kernel
> > > 2.6.17-1-amd64-k8, libdevmapper 1.02.07-1, udev 0.093-1. The machine is
> > > a HP DL385 with QLA2312 FC card.
> > >
> > > Basically, at boot time, multipath does not recognise all the paths. The
> > > underlying LUNs are visible, the mid-layer allocates /dev/sd* device
> > > names, but not all the paths are not used:
> > >
> > > newftp1b:~# lsscsi -d | grep ':1]'
> > > [0:0:0:1] disk COMPAQ HSV110 (C)COMPAQ 3028 /dev/sda[8:0]
> > > [0:0:1:1] disk COMPAQ HSV110 (C)COMPAQ 3028 /dev/sdi[8:128]
> > > [1:0:0:1] disk COMPAQ HSV110 (C)COMPAQ 3028 /dev/sdq[65:0]
> > > [1:0:1:1] disk COMPAQ HSV110 (C)COMPAQ 3028 /dev/sdy[65:128]
> >
> > The EVAs are strange beasts... You are running an EVA5000 with firmware
> > 3.028. That makes it an active/passive controller. In addition,
> > although each HSV controller in the EVA has 2 paths to each fabric, only
> > 1 path is actually ever used and the other is there in case the first
> > fails. So...your storage is really available on only 1 of the 4 paths.
> >
> > My personal solution to the EVAs on Linux is to just use the qlogic
> > failover driver. It just works. That's not to say that there isn't a
> > problem in the multipath software - I'm just saying that you don't need
> > the multipath suite to make stuff work (in this case).
> >
> > .../Ed
> >
>
> --
> dm-devel mailing list
> dm-devel at redhat.com
> https://www.redhat.com/mailman/listinfo/dm-devel
--
Ed Wilts, RHCE
Mounds View, MN, USA
mailto:ewilts at ewilts.org
Member #1, Red Hat Community Ambassador Program
More information about the dm-devel
mailing list