[dm-devel] dmsetup load not working?
Bob Bell
Bell_Robert at emc.com
Sat Dec 8 18:07:15 UTC 2007
On Sat, Dec 08, 2007 at 06:53:59PM +0100, Milan Broz wrote:
> There can be two tables for DM device, active and inactive.
>
> Active (live) table is used for operation, inactive is used
> in preparation for table change.
>
> "Inactive" table is activated during device resume (if you need to
> change table, suspend device and resume device is needed to switch
> inactive table to live state).
I missed that these were two separate slots, and that resume was the
trigger to use the inactive table. It makes a lot of sense now. That's
for taking the time to explain it. I should be all set now.
--
Bob Bell
More information about the dm-devel
mailing list