[dm-devel] [PATCH 2/3][RESUBMIT] scsi_dh_rdac: move the init code from rdac_activate to rdac_bus_attach

[Moger, Babu]

Moving the initialization code from rdac_activate to rdac_bus_attach which is more efficient.
We don't have to collect all these information during every activate.

Signed-off-by: Babu Moger <babu.moger at lsi.com>
Reviewed-by: Vijay Chauhan <vijay.chauhan at lsi.com>
Reviewed-by: Bob Stankey <Robert.stankey at lsi.com>

---

--- linux-2.6.31-rc5/drivers/scsi/device_handler/scsi_dh_rdac.c.orig	2009-09-02 10:06:46.000000000 -0500
+++ linux-2.6.31-rc5/drivers/scsi/device_handler/scsi_dh_rdac.c	2009-09-02 10:08:06.000000000 -0500
@@ -539,23 +539,11 @@ static int rdac_activate(struct scsi_dev
 {
 	struct rdac_dh_data *h = get_rdac_data(sdev);
 	int err = SCSI_DH_OK;
-	char array_name[ARRAY_LABEL_LEN];
 
 	err = check_ownership(sdev, h);
 	if (err != SCSI_DH_OK)
 		goto done;
 
-	if (!h->ctlr) {
-		err = initialize_controller(sdev, h, array_name);
-		if (err != SCSI_DH_OK)
-			goto done;
-	}
-
-	if (h->ctlr->use_ms10 == -1) {
-		err = set_mode_select(sdev, h);
-		if (err != SCSI_DH_OK)
-			goto done;
-	}
 	if (h->lun_state == RDAC_LUN_UNOWNED)
 		err = send_mode_select(sdev, h);
 done:
@@ -695,12 +683,20 @@ static int rdac_bus_attach(struct scsi_d
 	if (err != SCSI_DH_OK)
 		goto failed;
 
-	err = check_ownership(sdev, h);
+	err = initialize_controller(sdev, h, array_name);
 	if (err != SCSI_DH_OK)
 		goto failed;
 
+	err = check_ownership(sdev, h);
+	if (err != SCSI_DH_OK)
+		goto clean_ctlr;
+
+	err = set_mode_select(sdev, h);
+	if (err != SCSI_DH_OK)
+		goto clean_ctlr;
+
 	if (!try_module_get(THIS_MODULE))
-		goto failed;
+		goto clean_ctlr;
 
 	spin_lock_irqsave(sdev->request_queue->queue_lock, flags);
 	sdev->scsi_dh_data = scsi_dh_data;
@@ -712,6 +708,9 @@ static int rdac_bus_attach(struct scsi_d
 
 	return 0;
 
+clean_ctlr:
+	kref_put(&h->ctlr->kref, release_controller);
+	
 failed:
 	kfree(scsi_dh_data);
 	sdev_printk(KERN_ERR, sdev, "%s: not attached\n",