[dm-devel] A small question about Device Mapper
Mike Snitzer
snitzer at redhat.com
Mon Aug 24 00:22:25 UTC 2015
On Sun, Aug 23 2015 at 3:29am -0400,
Ni, Xun <xun.ni at intel.com> wrote:
> Hi, all:
>
> I use device mapper to config a thin-provision for a block device, with dmsetup, with the following command:
>
> Dmsetup create pool -table "0 `blockdev -getsize /dev/sdd1` thin-pool /dev/sdd2 /dev/sdd1 128 0"
> Dmsetup message /dev/mapper/pool 0 "create_thin 0"
> Dmsetup create snap1 -tabe "0 `blockdev -getsize /dev/sdd3` thin /dev/mapper/pool 0 /dev/sdd3"
>
> Everything works well, but when I reboot the system, the block device is gone, I need to create the pool again...
>
> Anyone has idea on how to make this config persistent? I need to boot the kernel , the dm pool device shows after the MD device found.
use lvm to create a thinp device that activates on bootup (see lvmthin
manpage).
More information about the dm-devel
mailing list