[dm-devel] split scsi passthrough fields out of struct request V2
Bart Van Assche
Bart.VanAssche at sandisk.com
Fri Jan 27 17:02:05 UTC 2017
On Thu, 2017-01-26 at 18:22 -0700, Jens Axboe wrote:
> What's your boot device? I've been booting this on a variety of setups,
> no problems observed. It's booting my laptop, and on SCSI and SATA as
> well. What is your root drive? What is the queue depth of it?
> Controller?
The boot device in my test setup is a SATA hard disk:
# cat /proc/cmdline
BOOT_IMAGE=/boot/vmlinuz-4.10.0-rc5-dbg+ root=UUID=60a4b064-b3ef-4d28-96d3-3c13ecbec43e resume=/dev/sda2 showopts
# ls -l /dev/disk/by-uuid/60a4b064-b3ef-4d28-96d3-3c13ecbec43e
lrwxrwxrwx 1 root root 10 Jan 27 08:43 /dev/disk/by-uuid/60a4b064-b3ef-4d28-96d3-3c13ecbec43e -> ../../sda1
# cat /sys/block/sda/queue/nr_requests
31
# lsscsi | grep sda
[0:0:0:0] disk ATA ST1000NM0033-9ZM GA67 /dev/sda
# hdparm -i /dev/sda
/dev/sda:
Model=ST1000NM0033-9ZM173, FwRev=GA67, SerialNo=Z1W2HM75
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=0
BuffType=unknown, BuffSize=unknown, MaxMultSect=16, MultSect=off
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=1953525168
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 udma5 *udma6
AdvancedPM=no WriteCache=disabled
Drive conforms to: Unspecified: ATA/ATAPI-4,5,6,7
* signifies the current active mode
Bart.
More information about the dm-devel
mailing list