[dm-devel] [PATCH 3/5] multipath: set verbosity to default during config

[Benjamin Marzinski]

condlog was setting the verbosity to 0 if there was no configuration.
This keeps multipath from printing warning messages about config file
problems that are found while loading the configuration. Instead, it
should use the default config level until it loads the configuration
to find the current value.

Signed-off-by: Benjamin Marzinski <bmarzins at redhat.com>
---
 libmultipath/debug.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/libmultipath/debug.c b/libmultipath/debug.c
index fbe171a..f89b264 100644
--- a/libmultipath/debug.c
+++ b/libmultipath/debug.c
@@ -11,6 +11,7 @@
 #include "../third-party/valgrind/drd.h"
 #include "vector.h"
 #include "config.h"
+#include "defaults.h"
 
 void dlog (int sink, int prio, const char * fmt, ...)
 {
@@ -21,7 +22,7 @@ void dlog (int sink, int prio, const char * fmt, ...)
 	va_start(ap, fmt);
 	conf = get_multipath_config();
 	ANNOTATE_IGNORE_READS_BEGIN();
-	thres = (conf) ? conf->verbosity : 0;
+	thres = (conf) ? conf->verbosity : DEFAULT_VERBOSITY;
 	ANNOTATE_IGNORE_READS_END();
 	put_multipath_config(conf);
 
-- 
2.7.4