[dm-devel] multipath target and non-request-stackable devices

[Drew Hastings]

Firstly, thanks for the hard work you guys are doing on the dm drivers.

I'm curious to know if I correctly understand the limitations of the
multipath target. I'm using kernel 4.19.0-rc5

When attempting to create a device from two NVMEs connected over nvme_rdma
/ nvmf, I get the following message:

[43012.002418] device-mapper: table: table load rejected: including
non-request-stackable devices
[43012.004067] device-mapper: table: unable to determine table type

Here's an example request that will fail:

dmsetup create test_path --table "0 1562824368 multipath 0 0 2 1
round-robin 0 1 1 /dev/nvme1n1 1 round-robin 0 1 1 /dev/nvme2n1 1"

This will work:

dmsetup create test_path --table "0 1562824368 multipath 0 0 2 1
round-robin 0 1 1 /dev/sdc 1 round-robin 0 1 1 /dev/sdb 1"

After looking at dm-table.c, it seems like this may be an issue of these
underlying devices not being compatible with the multipath driver. I had
noticed this same error when trying "non-physical" devices in other tests,
such as trying to multipath other virtual devices.

Is there anything that can be done to do the (relatively "basic") multipath
that detects IO errors and switches to the other device? It seems like
fundamentally multipath's error detection works in the same way raid1
implements IO error detection of the underlying devices, so why is it that
multipath seems to have this limitation but raid1 does not?

Is md-multipath.c still in use? It seems like it might not have this same
restriction on the underlying device.

Thank you so much for your time!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://listman.redhat.com/archives/dm-devel/attachments/20181031/6fb08b2a/attachment.htm>