[dm-devel] [PATCH 1/3] block: fix blk_rq_get_max_sectors() to flow more carefully

[Damien Le Moal]

On 2020/09/15 10:10, Damien Le Moal wrote:
> On 2020/09/15 0:04, Mike Snitzer wrote:
>> On Sun, Sep 13 2020 at  8:46pm -0400,
>> Damien Le Moal <Damien.LeMoal at wdc.com> wrote:
>>
>>> On 2020/09/12 6:53, Mike Snitzer wrote:
>>>> blk_queue_get_max_sectors() has been trained for REQ_OP_WRITE_SAME and
>>>> REQ_OP_WRITE_ZEROES yet blk_rq_get_max_sectors() didn't call it for
>>>> those operations.
>>>>
>>>> Also, there is no need to avoid blk_max_size_offset() if
>>>> 'chunk_sectors' isn't set because it falls back to 'max_sectors'.
>>>>
>>>> Signed-off-by: Mike Snitzer <snitzer at redhat.com>
>>>> ---
>>>>  include/linux/blkdev.h | 19 +++++++++++++------
>>>>  1 file changed, 13 insertions(+), 6 deletions(-)
>>>>
>>>> diff --git a/include/linux/blkdev.h b/include/linux/blkdev.h
>>>> index bb5636cc17b9..453a3d735d66 100644
>>>> --- a/include/linux/blkdev.h
>>>> +++ b/include/linux/blkdev.h
>>>> @@ -1070,17 +1070,24 @@ static inline unsigned int blk_rq_get_max_sectors(struct request *rq,
>>>>  						  sector_t offset)
>>>>  {
>>>>  	struct request_queue *q = rq->q;
>>>> +	int op;
>>>> +	unsigned int max_sectors;
>>>>  
>>>>  	if (blk_rq_is_passthrough(rq))
>>>>  		return q->limits.max_hw_sectors;
>>>>  
>>>> -	if (!q->limits.chunk_sectors ||
>>>> -	    req_op(rq) == REQ_OP_DISCARD ||
>>>> -	    req_op(rq) == REQ_OP_SECURE_ERASE)
>>>> -		return blk_queue_get_max_sectors(q, req_op(rq));
>>>> +	op = req_op(rq);
>>>> +	max_sectors = blk_queue_get_max_sectors(q, op);
>>>>  
>>>> -	return min(blk_max_size_offset(q, offset),
>>>> -			blk_queue_get_max_sectors(q, req_op(rq)));
>>>> +	switch (op) {
>>>> +	case REQ_OP_DISCARD:
>>>> +	case REQ_OP_SECURE_ERASE:
>>>> +	case REQ_OP_WRITE_SAME:
>>>> +	case REQ_OP_WRITE_ZEROES:
>>>> +		return max_sectors;
>>>> +	}
>>>
>>> Doesn't this break md devices ? (I think does use chunk_sectors for stride size,
>>> no ?)
>>>
>>> As mentioned in my reply to Ming's email, this will allow these commands to
>>> potentially cross over zone boundaries on zoned block devices, which would be an
>>> immediate command failure.
>>
>> Depending on the implementation it is beneficial to get a large
>> discard (one not constrained by chunk_sectors, e.g. dm-stripe.c's
>> optimization for handling large discards and issuing N discards, one per
>> stripe).  Same could apply for other commands.
>>
>> Like all devices, zoned devices should impose command specific limits in
>> the queue_limits (and not lean on chunk_sectors to do a
>> one-size-fits-all).
> 
> Yes, understood. But I think that  in the case of md, chunk_sectors is used to
> indicate the boundary between drives for a raid volume. So it does indeed make
> sense to limit the IO size on submission since otherwise, the md driver itself
> would have to split that bio again anyway.
> 
>> But that aside, yes I agree I didn't pay close enough attention to the
>> implications of deferring the splitting of these commands until they
>> were issued to underlying storage.  This chunk_sectors early splitting
>> override is a bit of a mess... not quite following the logic given we
>> were supposed to be waiting to split bios as late as possible.
> 
> My view is that the multipage bvec (BIOs almost as large as we want) and late
> splitting is beneficial to get larger effective BIO sent to the device as having
> more pages on hand allows bigger segments in the bio instead of always having at
> most PAGE_SIZE per segment. The effect of this is very visible with blktrace. A
> lot of requests end up being much larger than the device max_segments * page_size.
> 
> However, if there is already a known limit on the BIO size when the BIO is being
> built, it does not make much sense to try to grow a bio beyond that limit since
> it will have to be split by the driver anyway. chunk_sectors is one such limit
> used for md (I think) to indicate boundaries between drives of a raid volume.
> And we reuse it (abuse it ?) for zoned block devices to ensure that any command
> does not cross over zone boundaries since that triggers errors for writes within
> sequential zones or read/write crossing over zones of different types
> (conventional->sequential zone boundary).
> 
> I may not have the entire picture correctly here, but so far, this is my
> understanding.

And I was wrong :) In light of Ming's comment + a little code refresher reading,
indeed, chunk_sectors will split BIOs so that *requests* do not exceed that
limit, but the initial BIO submission may be much larger regardless of
chunk_sectors.

Ming, I think the point here is that building a large BIO first and splitting it
later (as opposed to limiting the bio size by stopping bio_add_page()) is more
efficient as there is only one bio submit instead of many, right ?


-- 
Damien Le Moal
Western Digital Research