dma error on startup

[Corey Taylor]

Hi all. I get the following message on startup:

Journalled Block Device driver loaded
hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
ide0: reset: success

Is this a cause for concern. Does this mean I have a bad hard drive?

Here's my lspci output:

00:00.0 Host bridge: Intel Corp. 82820 820 (Camino) Chipset Host Bridge
(MCH) (rev 04)
00:01.0 PCI bridge: Intel Corp. 82820 820 (Camino) Chipset AGP Bridge
(rev 04)
00:1e.0 PCI bridge: Intel Corp. 82801AA PCI Bridge (rev 02)
00:1f.0 ISA bridge: Intel Corp. 82801AA ISA Bridge (LPC) (rev 02)
00:1f.1 IDE interface: Intel Corp. 82801AA IDE (rev 02)
00:1f.2 USB Controller: Intel Corp. 82801AA USB (rev 02)
00:1f.3 SMBus: Intel Corp. 82801AA SMBus (rev 02)
00:1f.5 Multimedia audio controller: Intel Corp. 82801AA AC'97 Audio
(rev 02)
01:00.0 VGA compatible controller: nVidia Corporation NV5M64 [RIVA TNT2
Model 64/Model 64 Pro] (rev 15)
02:0c.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado]
(rev 78)

The hard drive itself is a Seagate Barracuda ATA VII, IIRC. The kernel
identifies it as: hda: ST340014A, ATA DISK drive.

Has anyone else observed this message? If so, can you interpret this for
me. Is this something I can fix through software, or is my drive
breaking down? Thanks in advance for any responses.

Corey