raid install problem

[Raymond Norton]

I set up raid level 1 with two 30 Gig drives on a new install. I select
"fill to maximum capacity"on each drive  and mounted it at / . Everything
looked as I expected before moving on with the install. The box boots and
runs fine, and I can see in the system logs that /dev/md0 is created using
hda1, and hdc1. I can pull hdc1 and the box boots fine without any errors or
complaining. If I pull hda1 I get  a "missing operating system error". I am
expecting to see the box boot with either one of the drives pulled.

Any advise would be appreciated.



Raymond