I got Fedora to install. Now, my network card doesn't work!

[Gilbert Sebenste]

Hi all,

Well, I did what a few told me to do on here. I downloaded the ISO's and 
installed the OS from my hard drive, instead of via http or FTP. It 
worked! Well, kinda. If you remember, I couldn't get my network card to 
work to install off of the 'net:

> class: NETWORK
> bus: PCI
> detached: 0
> device: eth
> driver: unknown
> desc: "3Com Corporation|unknown device 10b7:1700"
> vendorId: 10b7
> deviceId: 1700
> subVendorId: 1043
> subDeviceId: 80eb

> That board is a SysKonnect SK-98xx clone, the driver is *sk98lin*
(Thanks, Xose!)

So, installed off the hard drive. I go into redhat-config-networking 
and I delete the stupid card. Then, I try to reinstall it. Does fine 
until I try to activate it. Then...the message of doom in a box pops up:

"3c501 devoice eth0 does not seem to be present, delaying initialization."

OK gurus, what say you?

*******************************************************************************
Gilbert Sebenste                                                     ********
(My opinions only!)                                                  ******
Staff Meteorologist, Northern Illinois University                      ****
E-mail: gilbert at niu.edu                                               ***
web: http://weather.admin.niu.edu                                      **
Work phone: 815-753-5492                                                *
*******************************************************************************