HP PSC 2110
Santavy Peter
peter at santavy.sk
Thu Nov 20 10:27:03 UTC 2003
Hi Jim
> I have an HP PSC 2110 scanner/printer/copier that is supported under
> Linux using hpijs and hpoj (for sannning). It has worked perfectly
> under RH9, however in FC1, I can still print fine but scanning does not
> work. Xsane just says no scanners found. I have these three RPM's
> installed:
>
> hpoj-0.90-19
> libsane-hpoj-0.90-19
> hpijs-1.4-11
>
> I noticed that hpijs1.5 is out and hpoj-0.91 is out. I just compiled
> and installed hpoj-0.91, though it stil does not work.
>
> I have ran /etc/rc.d/init.d/hpoj setup and it finds the PSC fine and
> then I make sure hpoj is started with service hpoj start.
>
> Has anyone gotten this printer or one of the other supported HP PSC
> printers to work in FC1?
I use the device as scanner without any problem.
Installed RPM's:
hpoj-0.90-19
hpijs-1.4-11
libsane-hpoj-0.90-19
When I ran sane first time, I received the same message as you...
Then I have set it up by using:
>
>su...
>/etc/ini.d/hpoj setup
and after correct discovering of this usb device and setting as default
one, I could scan correctly.
I think you did the same steps :-(
Peter
--
__________________________________
Peter Santavy
peter at santavy.sk
http://santavy.sk
http://santavy.info
----------------------------------
Pouzivam legalny software -> pouzivam slobodny software
OpenSource - zadarmo a legalne
More information about the fedora-list
mailing list