pcnet_cs device eth0 does not seem to be present
Shu Hung (Koala)
koala at dg21.com
Wed Aug 4 14:11:10 UTC 2004
I have commented out the pcnet_cs entry in /etc/modprobe.conf and I've
done everything you told me to (include reboot). But when I did the
"rmmod pcnet_cs" step, an error message came out "ERROR: Module pcnet_cs
is in use".
What could possiblly be worng?
Christopher K. Johnson wrote:
>
> Comment out the pcnet_cs entry in /etc/modprobe.conf, and set
> ONBOOT=no in /etc/sysconfig/network-scripts/ifcfg-eth0, and reboot.
> Actually an 'rmmod pcnet_cs' and 'service pcmcia restart' should work
> in lieu of rebooting.
>
> The problem is your ethernet pcmcia card driver module is being loaded
> before pcmcia is started and the card controller module is loaded.
> This fails to work of course, and the later starting of pcmcia fails
> because the controller module conflicts with the already loaded card
> driver. The two changes above remedy the order things start in, and
> you will find that the ethernet interface does get started
> automatically at boot, because once pcmcia is started the card is
> detected and the interface for it is started.
>
> Chris
> Shu Hung (Koala) wrote:
>
>> After I install Fedora Core 2 onto my laptop, Sharp PC-FJ120R, I found
>> that the Fedora failed to detect the PCMCIA ethernet card. On the boot
>> process, it show the error message "pcnet_cs device eth0 does not seem
>> to be present".
>>
>> I am using Sharp PC-FJ120R with a Kingsoft PCMCIA ethernet card. I
>> though it is because Fedora lack the driver of the ethernet card. But my
>> friend said that the machine works well with Redhat 7.0......
>>
>> Any suggestions?
>>
>>
>>
>>
More information about the fedora-list
mailing list