Network Card Installation FC3
Andoni
andonilist at eurokom.ie
Mon Dec 13 18:24:43 UTC 2004
> > > As root type the following two commands:
> > >
> > > /etc/init.d/network stop
> > >
> > > /etc/init.d/network start
> > >
> > > This will restart the network and read your new setup. You should be
all
> > > set. There is a number of valid ways to set up the card ... this is
just
> > > the way I usually do it.
> > >
> >
> > This just get's stranger and stranger! I did that and it stopped only
the
> > loopback: perfect. Then /etc/init.d/network start and it started both
> > loopback and eth0, perfect. So then I did ifconfig and it gave me only
the
> > loopback.
> >
> > I tried the stop again and it only had the loopback to stop!
> >
> > Andoni.
> >
>
> When you ran netconfig did you select dhcp? If not, try it and it will
> rebuild all the network files for you and hopefully it was just some
> munged files. If that doesn't work then it might
> not be reading the card driver. You might have to load the module
> manually. Do an lsmod to make sure the ethernet card module is loaded.
> Also type lspci as root and make sure your card is being detected.
What am I looking for in lsmod?
Andoni.
More information about the fedora-list
mailing list