FC 3 Display Problems
William Lovaton
walovaton at yahoo.com.mx
Mon Dec 27 02:52:34 UTC 2004
I had a similar problem with my office PC. It uses an i810 video card
(I'm not sure).
I fixed it updating to the latest kernel and latest xorg with yum. Try
this and report back any other issue.
However there is a problem switching to different virtual terminals with
Ctrl + Alt + Fn. Every time I switch X crashes. This problem has
always been present in that specific hardware. I used to have Mandrake
9 in there and it had the very same problem. FC3 doesn't fix that.
-William
El dom, 26-12-2004 a las 19:32 -0600, Francisco Mendez escribió:
> Hi:
>
> I have installed FC3 on a machine with the following:
>
> P iii @ 800 MHz
> Motherboard Intel D815EEA
> 512 MB of Ram
> This machine is working with the integrated video card: (extract from
> lspci):
>
> ...
> 00:02.0 VGA compatible controller: Intel Corp. 82815 CGC [Chipset
> Graphics Controller] (rev 02) (prog-if 00 [VGA])
> Subsystem: Intel Corp.: Unknown device 4541
> Flags: bus master, 66Mhz, medium devsel, latency 0, IRQ 11
> Memory at f8000000 (32-bit, prefetchable) [size=64M]
> Memory at ffa80000 (32-bit, non-prefetchable) [size=512K]
> Capabilities: [dc] Power Management version 2
> ...
>
> After instalation all that I get is a black screen with previous
> colored garbage displays. After several attempts and reboots, the
> firstboot program tried to start but unsuccesfully.
>
> At the time I'm running FC1 on this machine, and thought it was time
> to move to FC3.
>
> Is there a possibility to run FC3 on this machine?
>
> Thx in advance for your help.
>
> Francisco Mendez
> --
> fedora-list mailing list
> fedora-list at redhat.com
> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
More information about the fedora-list
mailing list