FC2/Chronos video shutlle II

[Anne-Marie Michaud]

Hello, 

I've some problems with a TV card (Chronos Video Shuttle II which uses the philips saa7134 chipset). I search google a lot to find the correct number of card and tuner for this card. It appears that this card is the same than Flyvideo3000. So I load the driver with modprobe saa7134 card=2 tuner=3. 
dmesg gives me : 

saa7130/34: v4l2 driver version 0.2.12 loaded
saa7130/34: snapshot date 2004-10-05
ACPI: PCI interrupt 0000:00:0d.0[A] -> GSI 10 (level, low) -> IRQ 10
saa7130[0]: found at 0000:00:0d.0, rev: 1, irq: 10, latency: 32, mmio: 0xdffffc00
saa7130[0]: subsystem: 4e42:0138, board: LifeView FlyVIDEO3000 [card=2,insmod option]
saa7130[0]: board init: gpio is 38200
saa7130[0]: there are different flyvideo cards with different tuners
saa7130[0]: out there, you might have to use the tuner=<nr> insmod
saa7130[0]: option to override the default value.
saa7130[0]: registered input device for IR
saa7130[0]: i2c eeprom 00: 42 4e 38 01 10 28 ff ff ff ff ff ff ff ff ff ff
saa7130[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7130[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
tuner: chip found at addr 0xc2 i2c-bus saa7130[0]
tuner: type set to 3 (Philips (SECAM+PAL_BG) (FI1216MF, FM1216MF, FR1216MF)) by saa7130[0]
saa7130[0]: registered device video0 [v4l2]
saa7130[0]: registered device vbi0
saa7130[0]: registered device radio0

this look fine. but when I launch scantv, no station are found... 

What's wrong with my config?