AW: setting display resolution higher than 800*600 not possible with ELSA Gloria Synergy

[Thomas Butterstein]

Hello Brian,

thank you for your quick response. Can you tell me where i can find the
manual pages for this driver? where are the drivers located? And where the
settings for my monitor? Im quite new to Linux and RH9 made things a little
bit too easy I guess.

Regards

Thomas

-----Ursprüngliche Nachricht-----
Von: fedora-list-bounces at redhat.com
[mailto:fedora-list-bounces at redhat.com]Im Auftrag von Brian Richardson
Gesendet: Donnerstag, 9. Dezember 2004 09:14
An: For users of Fedora Core releases
Betreff: Re: setting display resolution higher than 800*600 not possible
with ELSA Gloria Synergy


Thomas Butterstein wrote:

>Permedia driver shows the same behaviour. In RedHat 9, I was able to select
>the amount of display RAM on the graphics adapter. This is not possible
with
>the one included in FC3.
>
XF86Config(5) should contain information about setting the correct value
for your card's video RAM. You may also have to look at your video
driver's manual page in section 4 (ELSA. Are they still using the nv(4)
driver?)

>which can be set up with the correct frequency values suiting my monitor's
>capabilities? Any help would be appreciated. Thank you!
>
>
Check your XF86Config's HorizSync and VertRefresh values to ensure they
are correct. If your exact monitor was in the list, it is nearly certain
that it will contain the correct values, but worth checking anyway.
Beyond that, there may be specific RAMDAC or dot clock issues with your
card. Details will be in your driver's section 4 manual page.

Brian

--
Brian Richardson
Software Developer
Public Key available at http://www.cubik.ca/


--
fedora-list mailing list
fedora-list at redhat.com
To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list