Low internet speed
Claude Jones
claude_jones at levitjames.com
Sun Dec 19 14:53:58 UTC 2004
I too am having this problem. I built this machine at work, where I
connect via switch and firewall to a T1. I moved the machine home where
I connect via a Linksys router to wireless broadband. Here are the
results of your suggested tests:
eth0 Link encap:Ethernet HWaddr 00:C0:F0:49:80:0C
inet addr:192.168.2.105 Bcast:192.168.2.255
Mask:255.255.255.0
inet6 addr: fe80::2c0:f0ff:fe49:800c/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:16380 errors:1 dropped:0 overruns:0 frame:0
TX packets:15728 errors:4 dropped:0 overruns:0 carrier:4
collisions:0 txqueuelen:1000
RX bytes:8110585 (7.7 MiB) TX bytes:1428328 (1.3 MiB)
Interrupt:10 Base address:0x4f00
dmesg | grep eth0
divert: allocating divert_blk for eth0
eth0: Lite-On 82c168 PNIC rev 32 at 0x1a834f00, 00:C0:F0:49:80:0C, IRQ
10.
eth0: Setting full-duplex based on MII#1 link partner capability of
45e1.
eth0: no IPv6 routers present
Both Evolution and Firefox are painfully slow, and take forever to do
anything. There do seem to be a lot of errors occurring on the
connection. I'm not sure what to make of the second command response.
How can this be fixed?
On Sun, 2004-12-19 at 07:53 -0500, Don Woodward wrote:
> On Sat, 2004-12-18 at 18:43, Danesh Daroui wrote:
> > Hi all,
> >
> > I am a FC3 user. I have connected a broadband internet CAT5 cable (8
> > Mbit/1 Mbit) to this system. Before FC3, I was using Windows XP and the
> > speed was fine, but when I installed FC3, the speed got low dramatically
> Sounds like you might have a duplex mismatch - you can use "ifconfig -a"
> and look for excessive errors - if you are connecting to a switch you
> should see none - if you are using a hub a few errors are OK.
>
> Check the speed on the Fedora end using "dmesg | grep eth0" to see it
> it's 10-half, 10-full, 100-half or 100-full duplex - make sure your
> switch is the same.
More information about the fedora-list
mailing list