kanguru micro cf
Eric Hartwell
darth_linux at ameritech.net
Sun Dec 19 21:39:40 UTC 2004
Hi all.
I have a kanguru micro cf drive and I can access the cf card when attached
using /dev/sda1. I cannot access the internal flash of the reader (mine has
32MB on board) using FC3. I used to be able to access the internal flash
as /dev/sda when I was running FC1, but not in FC2 and 3. Is there something
I can activate in the kernel or a module to install to make the kernel look
into the internal rom?
When I plug in the device without a cf card in, dmesg says
usb 2-2: new full speed USB device using address 5
scsi3 : SCSI emulation for USB Mass Storage devices
Vendor: USB CARD Model: READER Rev: 0.20
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi3, channel 0, id 0, lun 0
USB Mass Storage device found at 5
Device not ready. Make sure there is a disc in the drive.
thanks,
Eric
More information about the fedora-list
mailing list