New system and Seria ATA

[apjaworski at mmm.com]

Kevin,

I hope it is OK to bother you again about the SATA problem with Linux.  In
your answer to my original question (below) you mentioned that FC1
recognized your SATA drives with no difficulty.  Did you have to use the
supplementary block driver diskette (from the image directory on yarrow
disc1) or the install process from the FC1 CD took care of recognizing the
drives?

Did you by any chance install any MS Windows system on this hardware before
Linux.  If so, my understanding is that you need to follow a special
procedure and have a driver diskette when installing, say, W2k.

Thanks in advance,

Andy

__________________________________
Andy Jaworski
518-1-01
Process Laboratory
3M Corporate Research Laboratory
-----
E-mail: apjaworski at mmm.com
Tel:  (651) 733-6092
Fax:  (651) 736-3122


|---------+----------------------------->
|         |           Kevin Street      |
|         |           <kwsml at rogers.com>|
|         |           Sent by:          |
|         |           fedora-list-admin@|
|         |           redhat.com        |
|         |                             |
|         |                             |
|         |           01/22/2004 21:40  |
|         |           Please respond to |
|         |           fedora-list       |
|         |                             |
|---------+----------------------------->
  >-----------------------------------------------------------------------------------------------------------------------------|
  |                                                                                                                             |
  |      To:       fedora-list at redhat.com                                                                                       |
  |      cc:                                                                                                                    |
  |      Subject:  Re: New system and Seria ATA                                                                                 |
  >-----------------------------------------------------------------------------------------------------------------------------|




On Thu, 2004-01-22 at 21:50, apjaworski at mmm.com wrote:
> Hi everyone,
>
> I need to put together a new system and I have been thinking about Serial
> ATA drives.  I searched stuff using Google and I found out about SATA
> support for different chipsets.  I also found out about libata modules in
> 2.6.? kernels.  However, my question is this:  if I buy a brand new
> hardware with SATA disks only, is there any way to install Linux on it?
If
> so, could somebody explain how or point me to some explanations?

I have a couple of machines using ASUS P4P800 motherboards which use the
ICH5R controller for SATA.  I have a couple of Seagate SATA drives in
each (no IDE or SCSI drives).  I had no problem installing FC1, it
recognized them without difficulty.  I did not try the mb bios raid, but
did set them up with the Linux sw raid on some partitions.

The SATA drives show up as /dev/sda and sdb.  hdparm treats them as SCSI
drives, so doesn't show much.  The smart monitoring daemon doesn't seem
to be able to do anything with them, probably because it also thinks
they are SCSI drives.  Everything else that I've tried works fine and
these two issues I just ignore.

By the way, if you happen to use the same motherboard, plug your
speakers into the line in jack (really!).  You also have to tell the
install to use the sk98lin module to get the on board ethernet
recognized since it's not picked up by the probes.

--
Kevin Street
street at rogers.com


--
fedora-list mailing list
fedora-list at redhat.com
To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list