Kickstart installation

[Ed K.]

I think you'll find that the ip/gareway/dns parameters are only used
to download the kickstart file only. You mush enable networking in the
kickstart file too.

I have a installation setup, where the kickstart file is downloaded
when using a static ip address, then anaconda does a dhcp, and continues the 
network install.

ed

On Tue, 22 Jun 2004, Mark wrote:

> Thanks!
>
> One question before I try this (I just got stuck with something else for a
> while...):
> Does it matter if I assign a different IP address to eth0 in the kickstart
> configuration than I do in the boot parameters?
> As far as I understand, whatever I specify in the "network" command in the
> kickstart file is only used to generate the configuration file in the
> post-install and will only take effect once I boot from the newly installed
> system, right?
>
> Thanks,
>
> MARK
>
>> Try something
>>> like this:
>>>
>>> ip=192.168.1.17 gateway=192.168.1.1 dns=192.168.1.1 ks=http://...
>>
>> Oops, forgot 'ksdevice eth0' on that line as well.
>>
>> Forrest
>>
>>
>> --
>> fedora-list mailing list
>> fedora-list at redhat.com
>> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
>>
>
>
> --
> fedora-list mailing list
> fedora-list at redhat.com
> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
>

Security on the internet is impossible without strong, open, 
and unhindered encryption.