SCSI tape drive not seen in FC1?
Bill Grzanich
organix4 at mindspring.com
Wed Jun 23 18:17:01 UTC 2004
Hongwei Li wrote:
> Hi,
>
> We have installed FC1 on a new Dell P4 3Ghz pc. Everything runs well
> except that the scsi tape drive is not seen from fc1. When I boot the pc,
> the motherboard detects the scsi card and the scsi card detects the tape
> drive (this DDS4 is the only scsi device in this pc):
>
> AHA-2940UW v.2.11.0 ...
> SCSI ID: 2 SONY SDT-11000
>
> Then, the fc1 starts booting and I don't see any information about it.
<snip>
Which module is loaded? I suspect it's the newer version of aic7xxx.o. You
might try the old version "aic7xxx_old.o".
I have a similar tape drive, but I replaced the AHA-2940 with a Symbios
controller I happened to have, and it works fine under FC1.
Good luck.
-Bill
More information about the fedora-list
mailing list