Problems with FC 2 - Touch-pad and PCMCIA Ethernet card
Clive Long
rational_comms at yahoo.co.uk
Thu Jun 24 23:44:42 UTC 2004
Hi all
My network card has stopped working again
All I can say is that when I see the messages at
boot up time I see the attempt to start network
interface eth0 FAIL then later PCMCIA is started.
Surely this order of startup must be key to the
problem with PCMCIA NICs ???
I set the ONBOOT=NO but this did not result in th
eNIC being activated after reboot.
However, I am finding if in the "fedora network
device control" screens I completely delete both eth0
and hardware definitions then I reboot, that the
device is NOT seen on the NDC screens but it IS seen
when ifconfig is issued - and the network connection
is working
ifconfig
eth0 Link encap:Ethernet HWaddr
00:80:C7:44:74:94
inet addr:192.168.0.8 Bcast:192.168.0.255
Mask:255.255.255.0
inet6 addr: fe80::280:c7ff:fe44:7494/64
Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500
Metric:1
RX packets:9384 errors:0 dropped:0
overruns:0 frame:0
TX packets:7150 errors:0 dropped:0
overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:11937491 (11.3 Mb) TX bytes:751566
(733.9 Kb)
Interrupt:3 Base address:0x300
Weird stuff
I am not confident this approach will result in a
stable NIC
Clive
___________________________________________________________ALL-NEW Yahoo! Messenger - sooooo many all-new ways to express yourself http://uk.messenger.yahoo.com
More information about the fedora-list
mailing list