GRUB configuration after installing new kernel

[Luciano Miguel Ferreira Rocha]

On Sat, May 08, 2004 at 03:06:29PM +0200, mailing-lists at dragoneyedesign.net wrote:
> I have compiled a new kernel and put the bzImage in
> /boot/kernel-2.6.5/bzImage (boot is a separate partition).
> 
> I opened my grub.conf file and added:
> title Kernel 2.6.5
> root hd(0,2) =>this line was like that in the old kernel config so i copied it to the new config
> kernel /kernel-2.6.5/bzImage root=/dev/sda6 ro 
> 
> and I think that the last line is the cause of the problem. I get an error message that says that linux cannot mount.
> 
> but my Howto (yeah I'm like super-newbie) said that I had 
> to check the output from df and take the device that had the '/' mount point and that was /dev/sda6
> 
> Anyway,
> somewhere I must have made a big mistake
> 
> It would be nice if someone could correct me

Did you compile the driver for your scsi device? Not as a module, mind
you.

Regards,
Luciano Rocha