Linksys WPC54G and FC2

[Robert Spangler]

Hello,

I can seem for the life of me to get the 2 to work together.

I downloaded ndiswrapper and installed it according to the install 
instructions.

  'make install'

  make -C driver install
  make[1]: Entering directory `/temp/ndiswrapper-0.8-rc1/driver'
  make -C /lib/modules/2.6.5-1.358/build 
SUBDIRS=/temp/ndiswrapper-0.8-rc1/driver DRV_VERSION=0
.8-rc1 modules
  make[2]: Entering directory `/lib/modules/2.6.5-1.358/build'
  Building modules, stage 2.
  MODPOST
  make[2]: Leaving directory `/lib/modules/2.6.5-1.358/build'
  mkdir -p /lib/modules/2.6.5-1.358/misc
  install -m 0644 ndiswrapper.ko /lib/modules/2.6.5-1.358/misc
/sbin/depmod -a
  make[1]: Leaving directory `/temp/ndiswrapper-0.8-rc1/driver'
  make -C utils install
  make[1]: Entering directory `/temp/ndiswrapper-0.8-rc1/utils'
  install -m 755 loadndisdriver /sbin
  install -m 755 ndiswrapper /usr/sbin
  install -m 755 wlan_radio_averatec_5110hx /usr/sbin
  make[1]: Leaving directory `/temp/ndiswrapper-0.8-rc1/utils'


Then I install the drivers from the CD that came with the card.

  'ndiswrapper -i /mnt/cdrom/lsbcmnds.inf''

Then I look at the list.

  'ndiswrapper -l'

  Installed ndisdrivers:
  lsbcmnds        present

All looks good to this point.  I then run modprobe as instructed

  'modprobe ndiswrapper'

It states that there should be no errors which there wasn't.  Next I try to 
locate the wireless interface.

  'iwconfig'

  lo        no wireless extensions.

  sit0      no wireless extensions.

  eth0      no wireless extensions.

No wireless.  The card is in it's port but nothing.  Could some please tell me 
what I missed?  I would be grateful for any help on this matter.


-- 

Regards
Robert

Smile.....  It increases your face value.