[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: FC2 - HP cd4e USB - cdrecord can't burn CD



-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Will Backman wrote:
| I'm using an external USB HP cd-writer cd4e, and I am unable to burn
| CDs.
|
| When I plug it in, I get the following output from the dmesg command:
| usb 1-1: new full speed USB device using address 2
| Initializing USB Mass Storage driver...
| scsi0 : SCSI emulation for USB Mass Storage devices
|   Vendor: HP        Model: CD-Writer cd4f    Rev: 1.0A
|   Type:   CD-ROM                             ANSI SCSI revision: 02
| USB Mass Storage device found at 2
| usbcore: registered new driver usb-storage
| USB Mass Storage support registered.
| sr0: scsi3-mmc drive: 20x/20x writer cd/rw xa/form2 cdda pop-up
| Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
|
| When I attempt to burn using "cdrecord --dev=/dev/sr0
| FC2-i386-disc1.iso" I get:

Try cdrecord --dev=0,0,0 FC2-i386-disc1.iso
If you read the waring below, it says that it may have been
unintentional and not supported.  I think cdrecord in FC2 supports this
method....

| scsidev: '/dev/sr0'
| devname: '/dev/sr0'
| scsibus: -2 target: -2 lun: -2
| Warning: Open by 'devname' is unintentional and not supported.
| cdrecord: No such file or directory. Cannot open '/dev/sr0'. Cannot open
| SCSI driver.
| cdrecord: For possible targets try 'cdrecord -scanbus'. Make sure you
| are root.
| cdrecord: For possible transport specifiers try 'cdrecord dev=help'.
|
| When I do "cdrecord -scanbus" as root, all it sees is my standard cdrom
| drive.
|
|
|
|

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (MingW32)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFAq696c7lFLjBWKW0RAlGBAKCAJpJcdd59EFPD71Ut9V7/rYmutACcDhlV
MVQLKBRC1tTzaj8qoNPm5mA=
=fJbX
-----END PGP SIGNATURE-----



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]