message "unable to align partition" during install
shrek-m at gmx.de
shrek-m at gmx.de
Sun May 23 20:36:56 UTC 2004
Marc Mouriès wrote:
>Hi,
>
>during the install a message dialog appears saying "unable to align
>partition"
>i ignored the message but after the setup ran well the boot hangs.
>
>Any idea ?
>
update from RHL9 - FC2, no great problems
fc2 is booting.
while installation i had the same message "unable to align partition"
switching to tty1 will tell you:
"unable to align partition properly.
this probably means that an other partitioning tool generated an
incorrect partition table, because it didn´t have the correct BIOS geometry.
it is safe to ignore, but ignoring may cause (fixable) problems with
some boot loaders.
96"
switching to tty2 you could see something like this with sfdisk:
# sfdisk -l
[...]
warning:
the partition table looks like it was made for C/H/S=*/255/63 (instead
of 77557/16/63)
for the listing i assume this geometry
warning:
start = 63 - this looks like a partition rather than the entire disk
what luck that i have no win-dual-boot :-)
msi-nforce1-board
# dmidecode | head -39
# dmidecode 2.2
SMBIOS 2.3 present.
37 structures occupying 990 bytes.
Table at 0x000F0800.
Handle 0x0000
DMI type 0, 19 bytes.
BIOS Information
Vendor: Award Software International, Inc.
Version: 6.00 PG
Release Date: 05/29/2003
Address: 0xE0000
Runtime Size: 128 kB
ROM Size: 256 kB
Characteristics:
ISA is supported
PCI is supported
PNP is supported
APM is supported
BIOS is upgradeable
BIOS shadowing is allowed
ESCD support is available
Boot from CD is supported
Selectable boot is supported
BIOS ROM is socketed
EDD is supported
5.25"/360 KB floppy services are supported (int 13h)
5.25"/1.2 MB floppy services are supported (int 13h)
3.5"/720 KB floppy services are supported (int 13h)
3.5"/2.88 MB floppy services are supported (int 13h)
Print screen service is supported (int 5h)
8042 keyboard services are supported (int 9h)
Serial services are supported (int 14h)
Printer services are supported (int 17h)
CGA/mono video services are supported (int 10h)
ACPI is supported
USB legacy is supported
AGP is supported
LS-120 boot is supported
ATAPI Zip drive boot is supported
--
shrek-m
More information about the fedora-list
mailing list