Netgear WG511 && WEP (on an emachine)
sstengler at covad.net
sstengler at covad.net
Thu May 27 22:54:57 UTC 2004
Try entering the WEP with an "0x" in the front - ie., 0xhhhhhhhhhhhhhhh
wher the 'h's are your WEP key...
Sam Stengler
Anthony Presley <anthony at resolution.com> said:
> Hi All --
>
> I recently picked up an eMachine 6805, and got it up and running FC2,
> using the 64-bit version of the OS. Overall, it's not bad.
>
> I realize that the Broadcom 802.11g chip is a LONG way from being
> supported, at all (any change in this?), so I went out a picked up a
> Netgear WG511, 802.11g. This card uses the prism54 module / driver, and
> works VERY well if I do not use WEP.
>
> However, if I'm using WEP, it doesn't work at all. It cannot fetch an
> IP address, or anything. The hex key is being stored in
> /etc/sysconfig/networking/devices/keys-eth1, in the format:
> KEY=s:XXXXXXXXXXXXX
>
> I've tried with several different keys (always key 1 on the router), and
> two different routers / access points / firewalls. Under Windows, this
> same card has no problems.
>
> Is WEP working with prism54? What about on the 64-bit kernel?
>
> What else am I missing?
>
> --Anthony
>
>
> --
> fedora-list mailing list
> fedora-list at redhat.com
> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
>
--
More information about the fedora-list
mailing list