aic7xx system hangs
Hans Müller
ndof at gmx.li
Fri Sep 10 18:27:33 UTC 2004
Jeremy Conlin schrieb:
> I just checked the speed(s). The SCSI adapter that has the hard
> drives/RAID, all the devices are set to 80. The other SCSI adapter that
> controls the CD-ROM and tape drive has all the devices set to 20. Do
> they need to both be the same speed?
> Thanks,
> Jeremy
>
>
> On Sep 10, 2004, at 1:12 PM, Hans Müller wrote:
>
>> C. Linus Hicks schrieb:
>>
>>> On Thu, 2004-09-09 at 14:27, Jeremy Conlin wrote:
>>>
>>>> I recently installed Fedora Core 2 on a Dell PowerEdge 2400 server
>>>> that previously ran Red Hat 9. The installation appears to proceed
>>>> normally. The problem is it never boots entirely. It hangs with
>>>> the following as the last message (after removing quiet mode):
>>>>
>>>> Loading sd_mod.ko module
>>>> Loading aic7xxx.ko module
>>>
>>> Are you saying the installer is hanging, or that the install completed
>>> but now it won't boot the installed kernel?
>>
>> try to reduce the spedd of the diveces in the controller bios. I have
>> the same problem with a tape drive. After set the speed from 160 to
>> 80. it works.
>>
>>
>> --
>> fedora-list mailing list
>> fedora-list at redhat.com
>> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
>>
>>
>
>
No. Every device can have its own speed. look at the manual of the
harddisk and the cdrom/tape etc. what the maximal speed is.
More information about the fedora-list
mailing list