Module support for Broadcom ethernet
James Kosin
jkosin at beta.intcomgrp.com
Wed Apr 27 19:51:54 UTC 2005
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Geoffrey Leach wrote:
| I notice that the module that supports the Broadcom 5700 chip is
| tg3.ko, rather than bcm/bcm5700.ko, which is what you get when you
| build from the standard kernel sources (i.e., not rpm source).
|
| Anyone know the reason for this?
|
The reason is that the driver is a generic tg3 chip driver. Most
Ethernet and other drivers use known chip-sets to drive the hardware.
If you look carefully inside, you may see a chip on the board that
lists TG3 on the chip.
The reason for not having it be bcm5700.ko is you would end up with a
lot of modules with bcm5700.ko, bcm5702.ko, bcm5800.ko, etc. That may
be identical in every way. With a module named tg3.ko you can use the
same driver for many products that use the TG3 chip-set.
James Kosin
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.0 (MingW32)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org
iD8DBQFCb+1akNLDmnu1kSkRAqEuAJ0bF1npUO9m2qZfSN0gmHMQsu314gCdEfgq
2iWsZOBbCssf+dKRs8JrrUU=
=5IkC
-----END PGP SIGNATURE-----
More information about the fedora-list
mailing list