Tape backup using tar
Stuart Bailey
stuart at linusoft.co.uk
Tue Aug 9 18:59:30 UTC 2005
> By experiment, if I 'modprobe st' on s freshly booted system
> with no scsi tape plugged in, I dont get /dev/st0 created,
> so I suspect your tape is not visible on the SCSI bus.
> What does 'cat /proc/scsi/scsi' show?
# cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 03 Lun: 00
Vendor: HP Model: C7438A Rev: V312
Type: Sequential-Access ANSI SCSI revision: 03
I think yhis looks OK.
Many thanks,
Stuart.
--
---------------------------------------
Stuart Bailey BSc (hons) CEng CITP MBCS
LinuSoft (Proprietor)
Linux Specialist
(01953) 601294
(07778) 383739
http://www.linusoft.co.uk
----------------------------------------
**********************************************************************
This email and any files transmitted with it are confidential. If you
are not the intended recipient, please email postmaster at linusoft.co.uk
immediately.
You should not copy or use this email or attachments for any purpose
nor disclose their contents to any other person.
NO BINDING CONTRACT WILL RESULT FROM THIS E-MAIL UNTIL SUCH TIME AS A
WRITTEN DOCUMENT IS SIGNED ON BEHALF OF LinuSoft.
LinuSoft cannot accept any responsibility for the completeness or
accuracy of this message as it has been transmitted over public networks.
*************************************************************************
More information about the fedora-list
mailing list