Linksys WPC54Gv2 + acx111 + FC4
Efthym
efthym at gmx.net
Sat Aug 20 21:31:25 UTC 2005
Hi all,
I've been trying to setup up this card using the native linux driver with
no luck. I followed the directions at
http://www.houseofcraig.net/acx100_howto.php
since "lspci -n" says the chipset is 104c:9066. I downloaded
acx100-0.2.0pre8_plus_fixes_57.tar.gz and copied RADIO16.BIN from the
vendor cd to /usr/share/acx. The module compiled and loaded perfectly, but
"iwlist wlan0 scan" does not return any results and DHCP does not receive
an IP. I'm not using WEP or any encryption.
Here are some outputs I get.
[root at purgatory WPC54Gv2_40826]# ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:13:10:16:95:7D
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11
[root at purgatory WPC54Gv2_40826]# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11b+/g+ ESSID:"CHRAV"
Nickname:"purgatory.bakouria.org"
Mode:Managed Frequency:2.412 GHz Access Point:
00:00:00:00:00:00
Bit Rate:54 Mb/s Tx-Power=15 dBm Sensitivity=1/3
Retry min limit:7 RTS thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root at purgatory WPC54Gv2_40826]# iwlist wlan0 scan
wlan0 No scan results
Any help appreciated .
More information about the fedora-list
mailing list